Ceramic Window Tint — Maximum Performance, Lifetime Results

Yes — significantly. Ceramic IR film uses nano-ceramic particles that specifically target the infrared spectrum, which is the actual heat in sunlight. It blocks up to 60%+ of solar heat and up to 96% of infrared radiation. Standard dyed or metallic tints block far less heat because they only reduce visible light, not infrared. The difference is immediately noticeable — your car stays dramatically cooler even on a light shade.

Yes, ceramic tint is legal in New York — the key is choosing the right shade. New York State law requires front side windows to have a minimum of 70% VLT (Visible Light Transmission). Rear side and rear windows can be any shade. We know New York tint law inside out and will always recommend compliant shades for your vehicle. Ceramic IR at 70% VLT is nearly invisible while still providing significant heat and UV protection.

Ceramic IR window film is built to last a lifetime — literally. Unlike dyed films that fade or turn purple within a few years, ceramic IR maintains its performance and color clarity for the life of the vehicle. Every installation we perform comes with a lifetime manufacturer warranty. You will never need to re-tint because the film failed.

No — not meaningfully, when the correct shade is chosen. Ceramic IR film maintains excellent optical clarity. At 35% VLT or higher, night visibility is comfortable for most drivers. At 70% VLT (NY-legal for front windows), you'll barely notice the tint is there visually. We'll recommend the right shade for your driving conditions and visibility comfort. Ceramic IR is also non-metallic, so there's zero glare distortion like you can get with metallic films.

Regular tint (dyed or metallic) primarily blocks visible light. Ceramic IR goes further — it blocks the invisible infrared radiation that causes heat, using ceramic nano-particles that are non-metallic and non-conductive. The result: your car is cooler even at lighter shades, there's no signal interference, and the film lasts a lifetime without fading.

Yes. We have extensive experience with Tesla Model 3, Model Y, Model S, and Model X — including the full panoramic glass roofs. Tesla's large glass surfaces transmit significant heat, making Ceramic IR the ideal choice. We use film specifically rated for high solar transmission glass.

Yes. A deposit is required to secure your appointment slot. This ensures we're fully prepared for your vehicle and that your time is properly reserved. The deposit is applied to your total service cost. We operate by appointment only — no walk-ins.

Pricing depends on your vehicle, the number of windows, and the film package. Ceramic IR is a premium product, so it costs more than budget dyed film — but the heat rejection, clarity, and lifetime warranty make it the best long-term value. Call 914-217-2897 for a precise quote for your vehicle.

A typical full-vehicle Ceramic IR installation takes a few hours. We work by appointment only and never rush — proper installation requires careful prep, precise cutting, and time for the film to set. We'll give you an accurate time estimate when you book.

Absolutely — luxury and EV vehicles are a specialty. Tesla panoramic roofs, BMW and Mercedes factory glass, and other high-end vehicles all benefit enormously from Ceramic IR's heat rejection. We use film rated for large, high-solar-transmission glass and install with precision befitting the vehicle.

No. Ceramic IR film is completely non-metallic and non-conductive, so it will not interfere with cell signal, GPS, Bluetooth, keyless entry, or radio. This is a major advantage over older metallic films, which can disrupt electronics.

We recommend waiting at least 3–5 days before rolling your windows down so the film can fully cure and adhere. Full curing can take a couple of weeks depending on weather. You may notice slight haziness or small water pockets during curing — this is normal and clears as the film dries.

Yes. We professionally remove old, faded, purple, or bubbling film and clean the glass thoroughly before applying new Ceramic IR. Proper removal and prep are essential for a flawless result — it's included as part of a re-tint.

Yes. If you prefer a DIY approach, we offer pre-cut Ceramic and Carbon tint kits cut to your exact vehicle and shipped nationwide. For guaranteed results and a lifetime warranty, though, professional installation is always the better choice.